12
2.2. Inserting SX-3000 into the projector
Please make sure the projector is powered off before installing SX-3000 on the projector.
Note:
Please check SX-3000 for any physical damage like loose or burnt component before
installing it into the projector.
Figure 7 Inserting SX-3000 into the projector.
Insert SX-3000 as shown in Figure 7. The SX-3000 should slide into the projector on the rails
provided by the IMB slot, and the SX-3000 faceplate should be flush with the other existing
faceplates once properly inserted.
Note:
When installing the SX-3000 into any NEC projector, it is recommended to install it into the top slot of
the projector. If the SX-3000 is installed into the bottom slot, the board runs the risk of coming in contact with
the below racks.
2.3. Projector Network
Connect the provided Cat 5e LAN cable from the SX-3000 Ethernet 2
port to the projector’s
Ethernet port. Please see
Section 6
for IP network instructions after the SX-3000 is installed.
3.
EXTERNAL MONITOR, KEYBOARD AND
MOUSE
Before the server can be operated through VNC from the projector, you will first need to connect
an external monitor to the front VGA connection, and a keyboard and mouse to the USB
connection of the SX-3000.
Note:
When using an external touch screen for the first time. An external keyboard and mouse is required
before the touch screen is calibrated.
