8
3.2 ON / OFF Commands for Modes & Functions
3.2.1 Motion sensor mode [M]
Command string:
[Security code]-[M]-[on]
example: 1234-M-on
When required, the motion sensor can be switched ON. It will then automatically set the
Tracker into the Track-Mode if movement is detected twice within 30sec-1minute. The
Motion sensor can be switched OFF again via command:
[Security code]-[M]-[off]
3.2.2 Geo-Fence mode [GEO]
Command string:
[Security code]-[GEO]-[on]
example: 1234-GEO-on
The Geo-fence feature allows the user to set a virtual boundary. The tracker will inform the
user when leaving this boundary. The radius of this boundary (circle) is set in default to
100 meters. The Geo-Fence mode van be switched off via command:
[Security code]-[GEO]-[off]
3.2.3 Power Saving mode [PS]
Command string:
[Security code]-[PS]-[off]
example: 1234-PS-off
The Power Save mode (PS) allows extended operation of the tracker without recharging
the battery. Battery life however depends on the uses of the various functions. The default
setting for Power Save is OFF.
If Power Save is switched ON, and the unit is only
powered from the internal battery, it will be switched off for the user-defined (“C”) periods
and will not respond to new SMS commands in those time intervals.
The Power Save mode can be switched on with command:
[Security code]-[PS]-[on]
3.2.4 Line-Output [LO]
(TRC0078 only)
Command string:
[Security code]-[Lox]-[on]
example: 1234-LO
X
-on (
X
=1 or 2)
To activate the Line-Out, the above command has to be sent. Without (
X
) it will activate
both output lines. They can be switched off with command:
[Security code]-[LOx]-[off]
3.2.5 TRACK mode [T]
Command string:
[Security code]-[T]
example: 1234-T
To switch on the Track mode when you automatically want regular position updates
The Track mode can be switched OFF with command:
[Security code]-[T]-[off]
example: 1234-T-off
