23
14. QUICK demo to get acquainted with the unit
1)
Install a SIM card in the unit and write down the number.
Ensure
no
PIN number is set and that card is activated and disable call-forwarding and
voice mail messaging. Initially activate the SIM card for the first time with a normal
mobile phone.
2)
Install the battery in the unit
. Connect the battery wires to the connector on the
PCB. Put the tracker on a place for a clear sky view.
3)
Type and Send SMS:
1234-R-TRK
to your tracker mobile phone number and you
should get information about the settings of the Track Mode.
4)
You will Receive a SMS after about 30-45 seconds like:
TRK: T0003R020C010
5)
Type and Send SMS:
1234-S
This command will instruct the tracker to send one
single (S-single) GPS coordinates position.
6)
You can expect to receive a SMS back with data like the message shown below:
Single Mode
Lon 114* 7’ 58.895”E
Longitude coordinates
Lat: 22* 21’ 42.816”N
Latitude coordinates
Height: 85.5m
Height above sea level
LOC 07:58:23
Local Time, or UTC time
10-01-2008
Date-month and year
7)
Send SMS:
1234-M-ON
This command will switch the motion sensor ON.
You will to receive a SMS back
“
Motion sensor is switched ON
”
8)
Shake the Tracker:
The motion sensor will trigger the tracker and it will send the message
“
Motion Alert
”
.
Wait about 30 seconds and shake it again.
You will receive a SMS
“
Vehicle is moving
”.
This will switch the tracker automatically in Track-Mode and you will receive SMS
messages similar to that listed above under point
6
, however the indication will be
Track Mode.
This will continue until the unit is stationary for some time, or reaching
the number of repeats (R020) or until you switch off the Track mode.
9)
Send SMS:
1234-T-OFF
This command will switch the Track-Mode OFF.
10)
Send SMS:
1234-M-OFF
This command will switch the Motion Sensor OFF.
11)
Send SMS:
1234-I-SOS1-xxxxxxxx
xxxxxxxx= Phone number of party to be
informed if emergency occurs. Number should be +country code, area code, phone
number. After sending above message the party will receive confirmation message that
in emergency cases she or he will received GPS coordinate information. The sender
will receive confirmation message like SOS1: xxxxxxxxxxx to confirm the set number.
Then press the SOS button on the Tracker and a moment later the party will receive
the SMS message “Emergency” + the GPS coordinates.
12)
Send SMS:
1234-I-SOS1-0
to erase the number. You will receive confirmation SMS
with Info “
SOS1 Erased
”.
13)
Send SMS:
1234-I-D
. This command will re-set the tracker back to the Default settings.
