18
10. Track Mode
Command String: <Password>-T
for Track Mode
example: 1234-T
The Track Mode is important in cases where a regular position check is important, for
example, when your vehicle is stolen and you want to track its route. Track mode is also
activated by the Motion sensor, or by geofencing if required.
The Default programming settings are:
T
0003
R
020
C
010
The meaning of these parameters are as follows:
T
=
Time between each SMS message with GPS coordinates that the device will send
while it is in the “Tracking” mode.
R
= Number of times the GPS position SMS messages is sent while in “Tracking” mode.
C
= This is the time delay between Checking for any new SMS messages when
operating from the internal battery only, and in Power Save mode.
10.1 Power Saving Mode ON, internal battery only:
10.2 Power Saving Mode OFF:
If the Power Saving Mode is switched OFF the tracker will always be in an active state.
This means that the GPS coordinates will be available as in warm stage within about 12
seconds. The parameters for T and R are still valid and can be set according your own
requirements. The parameter “C” however is not valid any more.
