GCC Technologies LaserPro FMC280, Руководство пользователя

Страница: 11 / 129

232002430G(03)
7
both your laser system and in this manual.
• Never leave the machine unattended during the laser cutting and engraving process. The
laser may ignite combustible materials. A well-maintained fire extinguisher and operational
smoke or fire detector should be kept in the vicinity of the machine.
y When processing Aluminum, carbon steel, magnesium (Mg), or metallic materials
with assisted Oxygen gas, it’s required to connect anti-explosion air ventilation
system externally to take out the metallic dust or debris carefully when working with
GCC FMC280 laser system. Hazardous or fire may occur if not follow the setup
requirement.
y Fasten the high-pressure gas valves tightly without falling, hazardous may occur.
y Caution—Use of controls, adjustments, or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
• Always wear safety goggles that will filter out 1064nm laser when the laser system is in
operation. Reflective materials such as mirrors, enameled brass and anodized aluminum may
partially-reflect some of the invisible laser radiation. Severe eye damage may occur if proper
safety goggles are not worn.
• Connect the machine to a properly grounded power outlet. Ensure the voltage of the power
source is identical to the voltage of the machine.
• Do not open the laser access panel when the machine is plugged in.
• Do not attempt to modify or disassemble the laser module.
• Do not attempt to remove or modify any component of the machine’s laser interlock safety
system.
• Ensure the immediate work area of the machine is well-ventilated. Odors, vapors, and dust
are by products generated during the laser engraving and cutting process. An exhaust system,
vacuum cutting box, and honeycomb table are recommended. Please contact GCC or your
local GCC distributor for more information.
• Do not laser heat-sensitive surfaces or materials that may generate toxic fumes, such as PVC
and Teflon.
y Resulting debris from laser cutting are very dangerous and may cause fire hazard, clean the
debris after machine usage.
y DO NOT leave any debris and scraps inside laser machine after job finished. Must keep
machine clean after job finished.
y Regularly clean and maintain your machine according to our cleaning and maintenance
instructions. Doing so will ensure your machine will operate effectively and safely over a
long period of time.
NOTE
Each LaserPro FMC280 machine is shipped with a single pair of safety goggles. If
additional safety goggles are required, please contact GCC directly or an authorized GCC
distributor. If you wish to purchase one on your own, please make sure the safety goggles
meet these requirements:
190 - 534nm OD5+
910-1070nm OD6+
Visible Light Transmission: 23.5%