GCC Technologies LaserPro C180, Руководство пользователя

Страница: 25 / 111

LaserPro C180 User Manual
19
4.2 Graphics Software Setup
The LaserPro C180 is compatible with graphics software that can output HPGL commands, such as
CorelDraw, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software
• Photoshop
• CorelDRAW
• Illustrator
• AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro C180, but these are not
supported. Any software that can output to the LaserPro Print Driver should work.
NOTE
• Support will not be offered, if you experience output problems with non-supported graphics
software.
• When you have the mass cutting production, we will suggest that you can select
AutoCAD to work with the LaserPro C180 to have better output performance.
4.2.1 Recommended Computer Configuration
The LaserPro C180 operates under Windows operating systems and is designed to work on a
computer that meets the following minimum requirements.
Personal Computer
■ Hardware Compatibility
• CPU
–
Pentium 90 (or equivalent) or greater
• RAM
– 32MB or higher
• FDD
– One 3.5" 1.44 MB Floppy Disk Drive
• HDD
– 1.2 GB Hard Drive or greater
• SVGA
– 15" Super VGA Monitor
• On Board Parallel Mode (Enabled from your motherboard’s BIOS):
• SPP
– Preferred Mode
• ECP
–
Cable (Less than 1.8 meters)
■ Software Compatibility
• The LaserPro C180 drivers are designed for Windows 2000, XP, or newer operating systems.
Macintosh Computer
■
Hardware Compatibility
• Mac OS X Leopard
•
At least 32 MB of actual RAM