TIRE CHANGER FOR TRUCK TWC-1600
25
The TWC-1600 tire changer has got a fork (1, Fig. A) which has been position
there on purpose for moving the machine.
Follow these instructions:
1) Low the turntable holding arm (2, Fig .A) completely down.
2) Close completely the jaws of the chuck (3, Fig. A).
3) Bring the sliding table (4, Fig. A) at the end of its travel, near the arm.
4) Insert into the lifting fork a hoisting belt (at least 60 mm wide and of a length
sufficient to bring the hook of the belt above the tire changer).
5) With the special belt ring bring the 2 ends of the belt together and lift with a
sufficiently strong lifting truck.
16 STORING
If the machine as to be stored for a long time 3-4 months you have to:
1) Close the jaws of the chuck; low the chuck holding arm down; low the tool
holding arm down, in working position.
2) Disconnect the machine form all power sources.
3) Grease all the parts that could be damaged if they dry out:
-
the chuck
-
the slot of the tool holding arm
-
the slides of the carriage
-
the tool
Empty oil/hydraulic fluid reservoirs and wrap the machine in a sheet of
protective plastic to prevent dust from reaching the internal working parts.
If the machine as to working again after a long storing period, it is necessary to :
-put the oil into the reservoirs again.
-with a turn screw press the pin on the middle of the electro-valves of the
hydraulic power pack (see Fig .X) in order to manually unlock the electro-Valves
which could be locked after a long period of inactivity.
-restore the electric connection.
17 SCRAPPING A MACHINE
When you machine’s working life is over and it can no longer be used, it must
be made inoperative by removing any connection to power sources.
These units are considered as special waste material, it should be broken down
into uniform parts and disposed of in compliance with current laws and
regulations.
If the packing are not polluting or non-biodegradable, deliver them to
appropriate handlind station.
