Instructions for DKC500ACL/DKC800ACL
www.gatexpertstore.com
13
To Reset: Turning the power off will reset the limit switch stop memory. Power on the gate
opener again, pressing remote control or external push button switch to open and then
close the gate once, then new limit switch stop setting is completed.
Step 8 - Powering on
·
Ensure that the outer cover has been fitted and fastened back onto the motor base.
·
Before powering up the gate opener make sure the gate can travel by hand in manual mode
(key unlocked).
·
Slide the gate to between the middle of the posts, approximately (see below diagrams).
·
Lock the manual release spanner (key locked) in readiness for automatic mode.
·
Plug the power cord into an approved RCD protected weatherproof outlet.
·
Remote controls included in this kit are factory paired ready for use.
Figure 15
Open Position Limit Switch Stop
Closed Position Limit Switch Stop
Motor
Magnet
Gate
