Instructions for DKC500ACL/DKC800ACL
www.gatexpertstore.com
1
Then the gate will move in
the set direction.
Default Setting Instruction
The gate opener will open the gate to the right-hand side as its default setting. By default, the
opener mounts on the right-hand side. (Figure 1)
Gate in closed position
Gate in open position
Figure 1
Before installation:
Test the gate opener by plugging it into a power source and pressing the
remote. Press the opening button, the output sprocket rotates, then press the stop button, the
output sprocket stops rotating. Finally, press the closing button, the output sprocket rotates to the
opposite direction. This will give you an understanding of the way how the opener moves the gate.
Figure 2
Note: Ensure that the gate opener is unplugged before proceeding with installation. Please keep
fingers away from the motor output sprocket whilst it is turning.
If your gate needs to open from the other direction (to the left, refer to figure 3), your opener needs
to be mounted on the left-hand side as shown, the relative wires need to be swapped over, please
check under “Terminal Instructions” for swapping. (Factory default setting is for right-hand opening:
opener mounted on the right-hand side).
Figure 3
Any works done to the gate opener must be completed whilst the power is off, and the opener is
Press the first/top button
on the remote.
Rotating output sprocket will
drive the gate frame.
