Gateway Solo 3450, Руководство пользователя

Страница: 259 / 272

253
Regulatory compliance statements
www.gateway.com
Australia and New Zealand
Wireless devices
Low power, Radio LAN type devices (radio wave (RF) wireless communication devices), operating
in the 2.4 GHz Band, may be present (embedded) in your notebook system. This section is only
applicable if these devices are present. Refer to the system label to verify the presence of wireless
devices.
Wireless devices that may be in your system are only qualified for use Australia and New Zealand
if a C-tick mark and registration number is on the system label.
The power output of the wireless device or devices that may be embedded in your notebook is
well below the RF exposure limits as set by the Australia Communications Authority (ACA) and
Radio Spectrum management Group (RSMG).
EMI statement
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to the Australian/New Zealand standard AS/NZS 3548 set out by the Australian
Communications Authority and the Radio Spectrum Management Agency.
New Zealand telecommunication statement
(for products fitted with Telepermit-approved modems)
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work correctly in all respects with another
item of Telepermitted equipment of a different make or model, nor does it imply that any
product is compatible with all of Telecom's network services.
This equipment shall not be set up to make automatic calls to the Telecom ‘111’ Emergency
Service.
Some parameters required for compliance with Telecom’s Telepermit requirements are dependent
on the equipment (PC) associated with this device. The associated equipment shall be set to
operate within the following limits for compliance with Telecom’s specifications:
(a)There shall be no more than 10 calls to the same number within any 30-minute period for any
single manual call initiation, and
(b)The equipment shall go on-hook for a period of not less than 30 seconds between the end of
one attempt and the beginning of the next attempt.
The equipment shall be set to make sure that automatic calls to different numbers are spaced
such that there is no less than 5 seconds between the end of one call attempt and the beginning
of another.
The equipment shall be set to make sure that calls are answered between 3 and 30 seconds of
receipt of ringing.
Important Under power failure conditions, this telephone may not
operate. Make sure that a separate telephone, not
dependent on local power, is available for emergency use.