Gateway 9510, Руководство пользователя

Страница: 80 / 222

75 www.gateway.com
Installing a processor
9
Install the new processor into the processor socket. Make sure that:
■
The processor release lever is open all the way (135° from the closed position)
■
The triangular arrow on the corner of the processor aligns with the triangular
hole on the corner of the processor socket
■
The processor is flush with the socket.
10
Press the processor locking lever down until it clicks into place.
11
Place the heat sink on the processor, making sure the Thermal Interface Material (TIM)
is aligned between the heat sink and the processor.
12
Line up the four captive screws with the four posts surrounding the processor, then
gradually and evenly tighten the four captive screws to secure the heat sink to the
system board.
13
Follow the instructions in “Installing the air ducts” on page 47 .
14
Follow the instructions in “Closing the server case” on page 52 .
Important
If you install two processors onto the system board, for best
performance the processors should be the same speed. Otherwise,
applications that detect processor speed could cause problems.
If only one processor is installed, it must be installed in the CPU 1
socket.
8510725.book Page 75 Tuesday, May 17, 2005 5:45 PM