Gateway 901 Series, Руководство по замене

Страница: 53 / 65

48
Replacing Gateway Family Media Center Components
www.gateway.com
10
Remove the plastic cover that covers the heat sink grease on the bottom
of the replacement fan sink module.
11
Align the replacement fan sink module to fit inside the retention module,
then set the fan sink module on the processor.
12
Secure the fan sink module with the processor fan clips. Make sure that
the clips are correctly aligned and secured to hold the fan sink module in
place.
13
Reinstall the DVD drive bracket by following the instructions in “Replacing
the DVD drive” on page 10.
14
Reinstall the front bezel by following the instructions in “Replacing the
front bezel” on page 8.
15
Reinstall the case cover by following the instructions in “Closing the
Family Media Center case” on page 7.
16
Reconnect the power cord and modem, network, and all peripheral device
cables.
Replacing the system board
To replace the system board:
1
Follow the instructions in “Preventing static electricity discharge” on
page 3.
2
Shut down your Family Media Center, then disconnect the power cord and
modem, network, and all peripheral device cables.
3
Press the power button to drain any residual power from your Family Media
Center.
4
Remove the case cover by following the instructions in “Opening the
Family Media Center case” on page 5.
5
Remove the front bezel by following the instructions in “Replacing the
front bezel” on page 8.
6
Remove the DVD drive bracket by following the instructions in “Replacing
the DVD drive” on page 10. You do not need to remove the DVD drive
from the DVD drive bracket.
8509776.book Page 48 Monday, January 5, 2004 2:54 PM