GatesAir Intraplex DS-64NC, Инструкция по установке и эксплуатации

Страница: 37 / 68

3 – Installation & Configuration DS-64NC Synchronous Data Module
Version 9.1
GatesAir 3-3
Intraplex Products
3.3 Installation & Local/Remote Configuration
After completing the preliminary configuration steps, perform these steps to install the module and set
it up for local or remote operation:
For local control operation:
1.
Set the REMOTE switch off (S5/position 3 UP).
2. Turn service ON (S5/position 4 UP).
3. Install the module into the shelf (3.4 - Mounting).
For remote control operation:
1.
Before going into remote operation, the multiplexer common module must first recognize the
module and record its start-up settings. Therefore, begin by setting the REMOTE switch off
(S5/position 3 UP).
2. Turn the OFF switch on (S5/position 4 DOWN).
3. Install the module (3.4 - Mounting).
4. Wait 15 seconds to give the shelf common module time to recognize the module and copy its
parameter settings into memory.
5. Remove the module and set the REMOTE switch on (S5/position 3 DOWN). Do not turn service
on; that is, leave the OFF switch active.
6. Reinstall the module.
7. Verify the configuration via remote control by issuing a CONFIG? query. Section 2.8.1 discusses
the CONFIG? response.
8. Set service on via remote control (send SRVC = ON in a SET command).
You can now change the operating parameters for the module using ISiCL commands. Your
multiplexer operation manual gives details on using the Intraplex Simple Command Language
(ISiCL) for remote access and control.
3.4 Mounting
Insert the module into the selected slot in the Intraplex multiplexer (Figure 3-1).
Note: The module must be inserted so that the white ejector tab is at the bottom in a full size (5¼"
high) shelf or at the right in a compact (1¾" high) shelf.