GatesAir Intraplex DS-64NC, Инструкция по установке и эксплуатации

Страница: 58 / 68

DS-64NC Synchronous Data Module Appendix A –Module Adapters for the DS-64NC Module
Version 9.1
A-16 GatesAir
Intraplex Products
Table A-10. MA-428 Combinations of Auto-Negotiation and Forced Modes
AUTO
SW2/3
10/100
SW2/4
Half/Full
SW2/5 Function
Down X
N/A
X
N/A
Auto-neg 100 FD
Up Down Down 100 Mbps speed and full-duplex mode
Up Down Up 100 Mbps speed and half-duplex mode
Up Up Down 10 Mbps speed and full-duplex mode
Up Up Up 10 Mbps speed and half-duplex mode
Section A.4.2 – MA-428 Troubleshooting gives more information about various mode combinations.
The MA-428 module adapter has eight indicator lights. Table A-11 lists their names and descriptions.
Table A-11. MA-428 Indicator Light Descriptions
Light Color On/Off State Function
LINK
(Table A-14) Green
Blinks No valid link There may be a link between the module adapter
(MA) and the computer, but it is not valid.
On Valid links There is a valid link between the MA and the
computer.
Off No link There is no link between the MA and the
computer.
TX/RX Yellow Blinks Frame passing Ethernet frames are passing.
HALF Green
On Half-duplex The MA is operating in half-duplex mode.
Off Full-duplex The MA is operating in full-duplex mode.
10Mbps Green
On 10 Mbps The MA is operating at 10 Mbps speed.
Off 100 Mbps The MA is operating at 100 Mbps speed.
DROP Yellow
Blinks Data lost Data is being lost.
Off No data lost No data is being lost.
ALARM
(Table A-12)
Red
Blinks Alarm 1
There is an alarm condition.
On Alarm 2
Off Module OK There is no alarm condition.
TEST* Red
Blinks Module OK The MA is functioning properly.
On
Module not OK The MA is experiencing a problem.
Off
POWER* Red
On Module on The MA is powered up.
Off Module off There is no power to the MA.
* These indicator lights are on the top of the board (Figure A-12).
The MA-428 module adapter’s ALARM indicator light represents various error conditions (Table A-12).