Gates Underwater Products
•
5111 Santa Fe Street, Suite H • San Diego, CA • 92109
858.272.2501 • 800.875.1052 • Fax 858.272.1208 • [email protected] • www.GatesHousings.com
4
Side mount
Swivel
Top mount
Monitor bracket spans handles
Spacer(s) may be required
between handle and bracket
Swivel
base and
yoke.
Mounting to a Housing
Attachment of the EM419 to any housing is straightforward and generally the same
(with exception of the Gates XL1/XL1s housing). See photos below for typical
installations.
?
TRV / VX / PD / HD /GL housings
utilize
a bracket that secures to the handles
and spans the top of housing. In the center of the bracket the EM419 swivel base
will attach.
After mating the swivel base and yoke,
tighten the wing nut until the EM419
moves in all directions with enough
resistance to stay in the position you
desire, yet remain moveable for re-
positioning
?
XL1/XL1s housing.
An “L” shaped bracket is
attached to the left side of
the housing on a threaded
stud located directly above the left handle.
Note that the monitor can be mounted in two ways: offset to the side, or directly on
top of the housing (see photo. EM253 is shown.). Determine your preferred
mounting method and attach the “L” bracket appropriately using the ¼-20 nylock
nut and stainless washer.
