Gates Underwater Products
5111 Santa Fe Street, Suite H San Diego, CA 92109
858-272-2501 800-875-1052 Fax 858-272-1208 [email protected] www.GatesHousings.com
June 28, 2006
17
2. Verify Operation. You can check operation at this time by plugging in the monitor (see
below) and turning on the camera. Note – your Panasonic camera must be set to
display external video, as well as camera information. If you have not already set the
external video mode, please refer to the “
Preparing the Camera”
section for
directions.
3. Attach the monitor bracket to the swivel base on the small metal dovetail. (see
photo). Remove the wing nut and bolt from the monitor swivel yoke, and then mate
the swivel yoke and swivel base together far enough to re-insert the bolt. Tighten
until the monitor moves, but with some resistance.
4. Slide dovetail and monitor into the grooves on top of the housing and tighten in
place with thumb screws.
Monitor
swivel yoke
Plug in the external
monitor cable.
Wing nut
and bolt
Dovetail
Dovetail
Grooves
Thumbscrew
