Gatekeeper NiTRO 401, Руководство пользователя

Страница: 16 / 34

- 16 -
The table below indicates the wiring for CAB000218 shown in Figure 2.
POWER CABL POWER CABL POWER CABL POWER CABLE. E. E. E. CAB000219 CAB000219 CAB000219 CAB000219 (4PIN NiTRO (4PIN NiTRO (4PIN NiTRO (4PIN NiTRO
   
) : ) : ) : ) : CAB000262 CAB000262 CAB000262 CAB000262 (6PIN NiTRO (6PIN NiTRO (6PIN NiTRO (6PIN NiTRO----X X X X
   
))))
A BLACK GROUND
B RED POWER IN (Constant 12V)
C WHITE IGNITION (Switched 12v)
SENSOR CABLE. SENSOR CABLE. SENSOR CABLE. SENSOR CABLE. CAB000218 CAB000218 CAB000218 CAB000218
D GREEN ALARM
E YELLOW RECORD LED
F BLUE WARNING
G ORANGE STOP ARM
Table 2: CAB000219 / CAB000262 / CAB000218 Wiring Definitions.
Suggested System Locations. Suggested System Locations. Suggested System Locations. Suggested System Locations.
It is strongly recommended that the NiTRO

or NiTRO-X

be mounted inside the cabin area
of the vehicle where there is airflow and/or air conditioning. Mounting the NiTRO

or NiTRO-
X

in the Bulk Head or other enclosed area is not recommended.
Mounting Mounting Mounting Mounting The System. The System. The System. The System.
NOTE: NOTE: NOTE: NOTE: Mount the NiTRO

or NiTRO-X

DVR as far as practically possible from two way radio
antenna.
Use supplied mounting hardware with self tapping tech screws, #8 x ½” hex head
with internal star washer.
Apply even torque to fasteners to avoid distorting the mounting bracket.
Remember to leave enough space around the front of the DVR System so the top
mounting bracket can be easily installed, accessed, locked, and the SD card can
slide out freely.
When bolting the mounting bracket through sheet metal, use ‘fender’ washers on
the back of the sheet metal to help spread the torque load.
Route the all harness’ through the Rear to the installation destination(s).
- 53 -
Power Sensor Connection; NiTRO
Power Sensor Connection; NiTRO Power Sensor Connection; NiTRO
Power Sensor Connection; NiTRO

 

Pre
Pre Pre
Pre----December
December December
December 2011.
2011. 2011.
2011.
Original Power connection. Prior to December 2011 the following Power / Sensor Cables
were shipped with the NiTRO

.
NOTE: NOTE: NOTE: NOTE: NiTRO-X

has only shipped with Power / Sensor connection as covered in the
Installation section of this manual.
CAB000271 Connections. CAB000271 Connections. CAB000271 Connections. CAB000271 Connections.