Gatekeeper NiTRO 401, Руководство пользователя

Страница: 23 / 34

- 46 -
Using The GPS Zoom Feature. Using The GPS Zoom Feature. Using The GPS Zoom Feature. Using The GPS Zoom Feature.
When viewing the Vehicle Locator if you wish to
zoom-in there are two ways with which to
achieve this:
1) Use the Slider control to the left of the GPS
Mapping Window.
2) Place the cursor towards the Vehicle
Locator and when it changes to the GRAB
hand, double- click with the left mouse
button. This will auto-zoom in on the image.
Continue to do this until the required level of
zoom is achieved.
Continued usage will determine which method
you personally prefer.
Figure 30: GPS Zoom Feature.
MaxVIEW
MaxVIEW MaxVIEW
MaxVIEW
   
Features.
Features. Features.
Features.
Using The Scrubber. Using The Scrubber. Using The Scrubber. Using The Scrubber.
When searching for a specific incident reported during the run of the vehicle a useful tool to
become familiar with is the Scrubber. The Scrubber is the vertical bar located in MaxVIEW™
on the grey bar below the actual video display area, A in Figure 31.
With playback paused, Figure 31, the
Vehicle Locator becomes static within MAP
view.
Note the position of the Scrubber Bar in
relation to the Time (B) and where the
Vehicle Locator (C) is positioned.
Figure 31: Using the Scrubber Bar.
If the Scrubber bar is now moved either Backward
or Forward, depending upon the timestamp
required, the Vehicle Locator will also change its
relative position in the Map window.
Note the new position of the Scrubber and the
Timestamp (D) and the updated position of the
Vehicle Locator (E).
Figure 32: Vehicle Locator Updated Position
- 23 -
Video Alignment Cable: CAB000157 Video Alignment Cable: CAB000157 Video Alignment Cable: CAB000157 Video Alignment Cable: CAB000157
The following information explains the correct use of the Video Alignment Cable CAB000157.
With this cable an installer can temporarily view video on a monitor while they are physically
close to the camera in order to facilitate the aiming of the camera. The Video Alignment
Cable CAB000157 must be removed after the camera aiming is completed.