GAS GAS ENDURO 4T EC 2014, Руководство пользователя

Страница: 24 / 77

Owner´s manual
-24-
Multifunction gauge (Only on certain models and markets)
Homologation
NOTE: This chapter is not valid on XC models.
The vehicle just acquired is a vehicle approved under the EU directives and comply with all the requirements for type-approval.
The components of approval required to ride on public roads and to pass technical legislative inspections, which are detailed below.
The components of type-approval are identified with a determined and registered stamp
Each component of type-approval must be a part of your GAS GAS and in case of breakage, loss or malfunction you must go to your official
GAS GAS service to repair it.
Method 2
Find a totally flat surface. Make a mark on the flank of the tire and the ground.
Advance with the motorcycle until the wheel complete one revolution. Make a
mark on the ground at this point. Measure the distance between the marks of the
ground and convert to millimeters. Use this number as a measure of the wheel cir
-
cumference. For greater precision, the driver or an equivalent weight must remain
at the motorcycle during this process.
NOTA: In the same way as in Method 1, if you measure the wheel diameter in
inches, first multiply its diameter by 25.4 to convert it into millimeters. Once con -
verted, follow the instructions under ‘quick guide’ to complete this process.
Component list Amount/moto
Manufacturer identification plate 1
Catalyzed exhaust 1
Homologated Front and Rear sprockets 1
Carburetor jets 1
Front and rear turning lights 4
Plate holder 1
Speedometer 1
Electrical equipment, homologated lights 1
Horn 1
Rear-view mirror 2
Anti-theft lock 1
Air filter restriction 1
Throttle opening limiter 1
ProCarManuals.com