GAS GAS ENDURO 4T EC 2014, Руководство пользователя

Страница: 59 / 77

Owner´s manual
-59-
1
3
2
1
MAIN JET
Has a greater effect from 75% to 100% load. The number stamped on the
bottom of the jet (1) indicates the flow of fuel passing through the hole. A higher
number corresponds to a larger hole, more fuel passes.
NOTE: Never use “jet gauge sets” that are in the market. Its use is incorrect.
Always use new jets without manipulating (sealed in their bags).
DANGER
Gasoline is extremely flammable and can be explosive under certain conditions.
When you handle the carburetor, stop the engine and do not smoke. Make sure
the area is well ventilated and free from any source of sparks or flames (this inclu
-
des any appliance with a pilot light).
Carburetor setting
NEEDLE
The needle and the main jet together have an effect ranging from 25% to 75%
load. The needle moves into the main jet, when the needle narrows, changes from
cylindrical (1) to conical (2), its position determines the amount of fuel passing.
At the top of the needle are five slots (3) which sets the clip. This clip positions
the needle on the throttle valve and determines the relative position of the main
jet (that’s why the mix is enriched). Moving the clip up leans the mixture. Change
te clip position on step at a time (the cylindrical part of the needle affects the res
-
ponse to small throttle valve openings).
The position of the clip is set counting from the top position.
REFERENCE CARBURETION (COMPETITION USE ONLY)
EC250F EC300F EC450F
Carburetor type Keihin FCR-MX37 Keihin FCR-MX39
Main jet 160 160 162
Idle jet 42 42 48
Needle jet 68 68 65
Needle GDEQR GDEQR NFPR
Needle position
5ª
from top
Starter jet 115 115 NO
Pilot oir jet 70 70 70
Leak jet 70 70 60
Throttle stop screw Short Short Short
Mixture screw 1,5turn from fully closed 1,5 turn from fully closed 1 turn from fully closed
ProCarManuals.com