GAS GAS ENDURO 4T EC 2014, Руководство пользователя

Страница: 69 / 77

Owner´s manual
-69-
Troubleshooting
Fault Cause Solution
The engine does not crank. Seized crankshaft. Go to your GAS GAS official service.
Seized cylinder, piston, etc. Go to your GAS GAS official service.
Seized transmission assembly. Go to your
GAS GAS
official service.
The electric starter motor does
not crank The fusible of starter relay is fuse Remove the seat and check the fusible
Battery is discharged Remove the seat and check the battery voltage
The engine does no start. Motorcycle has been inactive for a long time. Unload the old fuel from the tank. When the
tank is filled with the new fuel, the engine will
start immediately.
Spark plug dirty or wet. Clean or dry the spark plug. If necessary, replace
it.
Engine flooded. To unflood the engine, close the fuel tap, remove
the spark plug, then put a gear and push the bike
several feet with the throttle fully open.
Visually you will know when the pre-compression
pan is empty. Mount the spark plug and start
the bike. You may have to remove the spark plug
again if the operation was not enough, the spark
plug will get wet and must be cleaned. Repeat the
pushing, mount the spark plug and the engine will
start.
DANGER
For your safety should wrap the spark plug cap
with a dry cloth. This is to prevent possible spark.
Incorrect air/fuel mixture Clean the fuel tank breather.
Clean the air filter.
Exhaust valve opened. Verify and correct the exhaust valve.
The engine starts but then stops. Incorrect air supply. Close the starter. Clean fuel tank air vent. Adjust
the air cleaner duct.
No fuel. Fill up the fuel tank.
The engine overheats. Insufficient coolant. Fill up coolant, verify the refrigeration system
watertightness.
Radiator is dirty or partially restricted. Clean radiator fins or replace it.
ProCarManuals.com