GAS GAS Enduro 2T 200CC, Руководство по ремонту

Страница: 60 / 72

Workshop manual
-60-
aSSemBlING THe eNGINe
- Carefully fit the gear shafts of primary shaft -1- and secondary shaft -2- at the
same time.
- Fit 2nd gear sprocket -1- and adjusting washer -2- to the primary shaft.
- Fit the desmodromic valve to the semi-crankcase making sure that it is aligned
with the marks (arrows) made during the dismantling.
- Place forks -1- into the grooves of the gears and in turn into the grooves of the
desmodromic valve.
- Then slide shafts -2- (short) and -3- (long) through the forks to their housings
on the semi-crankcase.
Note:
Checkthatthetransmissionfunctionscorrectlybyturningthedesmodromic
valvebyhand.
Positionthetransmissiongearsinneutral.
JOINING THE SEMI-CRANKCASES
- Turn the bedplate so that the left-hand semi-crankcase is facing upwards and
remove the nut that fixes the engine to the bedplate.
- Check that the contact surfaces of the left and right-hand semi-crankcases are
completely clean.
- Fit the centring bushings to the left-hand semi-crankcase.
- Fit the new gasket.
- Fit the right-hand semi-crankcase and tap with a plastic mallet until the two
surfaces are joined.
1
2
3
1
1
2
1
2
1