GAS GAS Enduro 2T 200CC, Руководство по ремонту

Страница: 27 / 72

Workshop manual
-27-
Dismantling the engine
- Install extractor ref. ME25950000 by turning the legs in the housing openings
of the ignition stator as shown in the picture.
Note:
Theextractorlegscanbeheightadjusted;theymustbeparalleltothesurface
of the semi-crankcase.
- Use the extractor to completely separate the left-hand semi-crankcase from the
right-hand semi-crankcase.
- During separation, detach the spacer bushing from the output sprocket (arrow)
located on the shaft.
Attention :
Donotusescrewdriversorleverstoseparatethesemi-crankcases!
REMOVING THE GEAR SELECTOR AND ASSEMBLY
- Remove the fork shafts (1) and forks (2).
- Mark the position of the desmodromic valve (3) with respect to the semi-
crankcase and then remove it.
- Remove the adjusting washer (4) and the 2nd gear sprocket (5).
- Remove the gear shafts (6) by carefully pulling them upwards.
Note:
The5thand1stgearsprocketsdonotcomeoutwiththegearshafts.
- Remove the 5th and 1st gear sprocket (arrows), needle roller bearing and
adjusting washers.
2
2
3
6
4
1
1
5
6