Garrett SmartScan, Руководство пользователя

Страница: 13 / 34

1556800.REV C SmartScan User Manual 13
6. Open the SmartScan door panel, remove the
rubber plug and feed both the power and the
RS485 cables through the hole into the Smart-
Scan detection unit. Run the power cable over the
battery source and plug it in behind the controller
cover. Next, plug the RS485 cable into the Smart-
Scan controller board. Organize loose cable into
the small open area underneath the feed through
hole. Close the SmartScan door panel. (Figure
2-9).
7.
Remove and reuse the screws to mount the
provided tie anchors in the locations indicated by
the arrows in Figure 2-10. Once anchors are
screwed in place, secure the loose wires to the
anchors using the cable ties provided.
8. Reconnect the AC power to the wall outlet and
turn on the PD 6500i/MZ 6100 walkthrough
unit.
STABILIZING
The SmartScan -enable walk-through metal detector may
be bolted directly to the floor using the holes in the unit’s
boot. Alternately, optional adhesive mounting plates or
stabilizer bar may be used.
Stabilizing the unit is particularly important in loca-
tions where the floor slopes or tilts, disorderly crowds,
high winds, etc., are possible. It is recommended that the
unit be tested for functionality and interference prior to
permanent mounting.
INSTALLATION COMPLETION
Complete installation of the SmartScan Thermal Screen-
ing Unit by warming up the system and conducting
ten sample screenings. This process is fully described in
"Operation" (Section 6 of this manual).
SmartScan does not ship with a fully charged battery.
It is therefore important to fully charge it before using
without AC connected. While SmartScan is now ready
for use, it is important to initially operate on AC power
to allow for at least 16 hours to fully charge the battery
before using remotely without AC.
Installation
Loose cable
Power cable connection
RS485 connection
FIGURE 2-10