Garrett SmartScan, Руководство пользователя

Страница: 15 / 34

1556800.REV C SmartScan User Manual 15
Note: SmartScan will cease operating on its inter-
nal battery power when the Garrett walk-through
metal detector is plugged into AC power. If AC
power is disconnected during operation, LED 1
on the exit side will show green, yellow, or red.
• Power Down
Hold down the SmartScan unit's power button for
approximately three seconds. Once the button is
released, a power-down alert will be heard. The
nine LED lights turn to yellow and then slowly
disappear from right to left on the exit side as the
unit powers down.
DESCRIPTION OF AUDIO RESPONSES
• Power On / Audio On
The SmartScan detector unit will give a three-
tone audio sound when turned on ranging from low
pitch to high pitch. This sound is the same for Power
On as well as Audio On.
• Power Off / Audio Off
When the power is turned on, the SmartScan unit will
give a three-tone audio sound, ranging from high
pitch to low pitch. This sound is the same for Power
Off as well as Audio Off.
• Feedback Audio
When the SmartScan system initially detects a face
and records the first temperature value, there will be
a single high pitch tone. This tone can be enabled or
disabled from the Garrett client interface under
"Feedback Audio". Default value is disabled. For
more info on Feedback Audio reference DEFAULT
SETTINGS/INFORMATION DISPLAYS
• Low Temp/Non-Read Audio
Low temp or non-read audio tones can be heard as
two tones, from high pitch to low pitch. This will be
heard when a detected temperature is lower than the
customizable temperature set point. The non-read
sound can only be heard when SmartScan is
connected to a Garrett walkthrough that is turned on.
• High Temp Audio
A person with a temperature higher than the temper-
ature set point will hear three high pitch tones for
high temp. The set point is set using the Garrett client
interface for both the "Multi Scan" Algorithm and
the "Statistical" Algorithm.
SMARTSCAN BASIC CONTROLS
• Power ON/OFF
Press and release the power button to turn the Smart-
Scan unit on. Press and hold the power button for
approximately three seconds and release to power off
the unit. The power button is located on the lower
right corner on the entry side of the SmartScan light
bar (see Figure 3-2).
Refer to "Installation Completion" in Section 2
for details on the SmartScan system warm-up process.
• Audio ON/OFF
Press and release the volume button to turn the
volume on and off. A three pitch audio tone will
sound for confirmation. The volume button is lo-
cated on the lower left corner on the entry side of the
SmartScan light bar (see Figure 3-2).
• Checking Battery Status
To check the SmartScan unit's battery status at any
time, quickly press and release the unit's power/bat-
tery button. All green LEDs on the exit side indicate
a 100% battery charge. At less than full charge, fewer
green LEDs will be lit.
When the internal battery has less than 30% life
remaining, the LEDs will be a yellow. When the bat-
tery has less than 10% life remaining, the LEDs will
be red.
Controls/Displays/Alarms
FIGURE 3-2, Patron Side (Entry Side)
Power /
Battery Check
Button
Volume
ON / OFF
Button