Page 16
810-PS2 Manual
11. If the alarms are used, route the wires into the display
enclosure. Connect the alarm wires to the gauge wires as
follows: Alarm 1 is the yellow wire, Alarm 2 is the orange wire,
Alarm 3 is the black wire, Alarm 4 is the red wire, Ground is the
green wire, and the automatic alarm is the purple wire. The
SpillStop output is the grey wire. Your display may also be
equipped with an optional green/yellow remote output wire.
To program the alarms see the programming section. See
the enclosed wiring diagram for connection of the automatic
alarm (the purple wire) and the optional remote output display
(the green/yellow wire).
12. Fasten on the display front panel and the hinged cover using
the stainless #8 screws provided. The lid can be mounted to
open up or down as desired. Be sure to coat the #8 screws
with anti seize compound such as CopperKote.
13.
Verify gauge operation by lifting the float. Record the unit
number, calibration units, minimum and maximum readout
values, and any alarm points programmed in the IMPORTANT
OPERATOR INFORMATION area on the front page of the
owner’s manual.
The truck operator must be given the
owners manual upon delivery with all front page data
filled in.
Содержание SeeLevel ProSeries II 810-PS2
Страница 30: ......
