HD-3WXL Operation and Installation Manual
7
Notice, this photo shows the correct jumper setting for 240 VAC.
Power Plug
Plug the EIA connector attached to the supplied power cord into the receptacle on the back of
the HD-3WXL.
Fuse Block
Located behind the Voltage Selection Panel, on the back side of the HD-3WXL, are six
separate fuses, one each for 100, 110, 120, 220, 230 & 240 VAC power. Only one fuse is used
at a time. Therefore, for any voltage range [100, 110, 120 VAC] or [220, 230, 240 VAC], the
two unused fuses from the same voltage range can be used as spares.
Placement
The degausser must be placed on a flat, hard surface with a minimum 6 inch (15cm) space
from any object that may interfere with the cooling fan exhaust located on the backside of the
degausser. As a general rule, media not intending to be erased should be kept at least 2 ft
(60cm) away from the degausser.
Cooling
Forced air-cooling is used to maintain safe operating temperatures within the degausser. The
air intake is located on the lower back panel and the exhaust is located on the upper back panel
of the degausser. To ensure proper cooling, do not block the air-intake and maintain a
minimum 6 inch (15cm) space from the back of the degausser to any obstacle.
