Garmin G1000 NXi, Дополнительное руководство по обслуживанию, Страница: 50 / 171

G1000 Supplemental Maintenance Manual Page 3-30
Textron Nav III Series Revision 3
190-02128-04
Initialize Fuel Cal Data (Only for CAN Bus Fuel sensors before fuel cal)
Follow this procedure to initialize fuel cal data. This section is only for aircraft with CAN Bus
Fuel Sensor and only before the fuel calibration is completed.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select
“Option –
INITIALIZE FUEL CAL DATA (only for CAN Bus sensors before fuel cal)
”
and press
the ENT key to select it.
Press the CHK All softkey.
In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the “CARD COPY” configuration check box. Press the
ENT key to uncheck
the configuration check box.
Press the Load softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green “PASS” in the Configuration and Software columns for each item loaded.
•
“Upload Complete………….COMPLETE” in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
Delete CAN Fuel Sensor Fuel Calibration (if installed)
Follow this procedure to delete the CAN Bus Fuel Sensor Fuel Calibration.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select
“Option –
Delete CAN Fuel Sensor Fuel Calibration
”
and press the ENT key to select it.
Press the CHK All softkey.
In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the “CARD COPY” configuration check box. Press the
ENT key to uncheck
the configuration check box.
Press the Load softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green “PASS” in the Configuration and Software columns for each item loaded.
•
“Upload Complete………….COMPLETE” in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.