Garland PASTA MAGIC, Инструкция по установке и эксплуатации

Страница: 7 / 24

Document # G_GHD_OM_PASTACUISINE_4607873 – 08/21 7
INSTALLATION INSTRUCTIONS Continued
and Resolve Radio-TV Interference Problems” helpful. It
is prepared by the Federal Communications Commission
and is available from the U.S. Government Printing Office,
Washington, DC 20402, Stock No. 004-000-00345-4.
Caster / Leg Installation
Depending upon the specific configuration ordered your
cooker may have been shipped without installed casters or
legs. If casters or legs are installed, you may skip this section
and proceed to Pre-Connection Preparations.
If your cooker requires the installation of casters or legs,
install them in accordance with the instructions included
in your accessory package.
Pre-Connection Preparations
DANGER
Do not connect cooker to gas supply before completing
each step in this section.
After the cooker has been positioned under the exhaust
hood, ensure the following has been accomplished:
1. Adequate means must be provided to limit the
movement of cookers without depending upon the
gas line connections. If a flexible gas hose is used, a
restraining cable must be connected at all times when
the cooker is in use. The restraining cable and installation
instructions are packed with the flexible hose in the
accessories box that was shipped with your unit.
2. Single unit cookers (GPC) must be stabilized by installing
restraining chains on cookers equipped with casters or
anchor straps on cookers equipped with legs. Follow the
instructions shipped with the casters/legs to properly
install the chains or straps.
DANGER
Do not attach an apron drain board to a single cooker.
The cooker may become unstable, tip over, and cause
injury. The appliance area must be free and clear of
combustible material at all times.
3. Level cookers equipped with legs by screwing out the
legs approximately 1 inch then adjusting them so that
the cooker is level and at the proper height under the
exhaust hood.
NOTE: There are no built-in leveling devices on cookers
equipped with casters. The floor where the cooker is to
be installed must be level.
NATIONAL CODE REQUIREMENTS
Pasta Magic cookers are manufactured to use the type of gas
specified on the rating plate. The rating plate is attached to
the inside of the cooker door. Connect a cooker only to the
type of gas indicated on the rating plate.
Installation shall be made with a gas connector that complies
with the national and local codes or regulations in force in
the country in which the appliance is being installed. Quick-
disconnect devices, if used, shall likewise comply with the
national and local codes or regulations in force in the country
in which the appliance is being installed
When installing Pasta Magic cookers in the UNITED STATES ,
the installation must conform to the latest edition of the
Nation Fuel Gas Code, ANSI Z223.1. In addition, installation
must comply with all local codes. In CANADA , installation
must conform to Standard CAN/CGA B149.1 or CAN/
CGA-B149.2, Installation Codes for Gas Burning Appliances
and Equipment. In addition, installation must comply with
all local codes. In AUSTRALIA , this appliance must be
installed by an authorized person in accordance with these
instructions, local gas and electrical regulations, and the
requirements of AA601, Installation Requirements for Gas
Burning Appliances.
For countries not specifically listed above, installation shall
comply with the national and local codes or regulations in
force in the country in which the appliance is being installed.
FCC COMPLIANCE
The user is cautioned that any changes or modifications to
Garland controllers not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Garland controllers have been tested and found to comply
with the limits for a Class A digital device, pursuant to Part
15 of the FCC rules. While these devices are verified as Class
A devices, they have been shown to meet the Class B limits.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of the equipment in residential
areas is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense. If necessary, the user should consult the dealer or
an experienced radio and television technician for additional
suggestions. The user may find the booklet “How to Identify