![background image](http://html.mh-extra.com/html/garland/mwe2w/mwe2w_installation-operation-and-service-manual_3644240007.webp)
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
PART #4527466 (12 Aug 2011)
Page 7
SAFETY
(continued)
WARNING:
This appliance must not be cleaned with a water jet.
DO NOT
apply ice to a HOT grill surface.
NOTE:
All warning labels and markings on the grill, which call attention to further dangers and necessary precautions.
HAZARD COMMUNICATION STANDARD, (HCS) -
The procedures in this manual include the use of chemical products. These
chemical products will be printed in
bold face,
followed by the abbreviation
(HCS)
in the text portion of the procedure. See the
Hazard Communication Standard, (HCS) manual for the appropriate Material Safety Data Sheet(s), (MSDS).
WARNING:
After turning the master power switch to the START position, the grill will go through an initialization process. If the
upper platens are in the lowered position they will return to their raised upper position.
MAINTENANCE
- the platen support arms carriage block bearing bushes, the platen adjuster nuts, the platen support (shoulder)
bolt and the cam follower should be checked annually for wear. Should there be any noticeable play in the bearing bushes and
any visible wear on the platen adjuster nuts, platen support bolts or cam follower, then they must be replaced.
MAINTENANCE
- the audible alarm that sounds at the end of a cook cycle is to advise the operator that the platen is about to
move. The function of this device may be tested by pushing the left hand CANCEL button. If no sound is heard, ensure that the
alarm volume is not set to low in SYSTEM SETUP. If there is still no sound then a service engineer should be called out to rectify
the fault.
SERVICE AND CLEANING
- The grill may be secured in the grill bay by the installer using two anchors that lock onto the front
casters. If the grill is to be moved out of the bay for cleaning or service, remove the anchor from each caster by turning the knob
counterclockwise to loosen the retainer. When the retainer is free of the caster, lay the assembly aside on the fl oor.
CLEANING
- NEVER clean the grill, interior or exterior, using a high-pressure sprayer, water jet, or any other liquid sprayer.
NOTE:
If anchors are present, the anchor assembly remains fastened to the back wall of the grill bay. After service or cleaning
is complete, return the grill to its position in the bay and reattach the anchors by placing the retainer on the caster post and
turning the knob clockwise to tighten. For safety reasons, the grill must be secured in the grill bay in this manner before opera-
tion can resume.