![background image](http://html.mh-extra.com/html/garland/mwe2w/mwe2w_installation-operation-and-service-manual_3644240017.webp)
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
PART #4527466 (12 Aug 2011)
Page 17
Items included with the purchase of your
new grill from manufacturer:
1. One (1) grill
2. One (1) gas hose (for gas grills only)
3. One (1) box containing:
a. Six (6) release material sheet
b. Release material clips
b–a. Eight (8) release material clips (2 Platen Grill)
b–b. Four (4) release material clips (1 Platen Grill)
c. Release material rear rods.
c–a. Two (2) release material rear rods (2 Platen Grill)
c–b. One (1) release material rear rods (1 Platen Grill)
4. One (1) box containing four (4) casters.
Items NOT INCLUDED from the manufacturer
and should be purchased from the KES:
1. Any electrical cords needed for application.
2. Any
fl ue box needed for application.
3. Any grease buckets or grease rails needed for
application.
THE FOLLOWING INSTALLATION
PROCEDURE CAN BE PERFORMED BY A:
•
FACTORY AUTHORIZED SERVICE CENTER
•
AN APPROVED INSTALLATION PERSON APPROVED BY
PURCHASER OF GRILL
•
LICENSED INSTALLER CONTRACTED BY KES (KITCHEN
EQUIPMENT SUPPLIER)
1. Uncrate unit from crating material
CAUTION:
PRIOR TO INSTALLATION, CHECK THE ELECTRICAL
SUPPLY TO ENSURE INPUT VOLTAGE AND PHASE
MATCH THE EQUIPMENT VOLTAGE RATING AND
PHASE. MANY LOCAL CODES EXIST, IT IS THE
RESPONSIBILITY OF THE OWNER/INSTALLER TO
COMPLY WITH THESE CODES.
NOTE: ENSURE THAT PLATENS ARE STRAPPED
DOWN SECURELY THROUGH STEP 3 TO PREVENT
PLATENS FROM RAISING. SEVERE DAMAGE MAY
OCCUR.
1
2
4
4
3
Note:
ĺ
Unpack Unit (Single or Double Platen), Only
Cut Straps That Secure Unit To Pallet.
ĺ
DO NOT
Remove Brace 1 & 2, AND
DO NOT
CUT STRAPS 3 & 4.
2. Tip unit over on its back. Install caster channels and
casters as shown. After installing, lock the rear casters.
3. Carefully rotate grill back on its casters. Now you may
cut and remove the platen securing straps.
4. Remove back body side and Install power cords per
your country / area’s specifi cations.
WARNING:
The appliances must be electrically grounded in
accordance with local codes, or in the absence of
local codes, with the National Electrical Code ANSI/
NFPA 70, or the Canadian Electrical Code CSA C22.1
as applicable.
INSTALLATION & STARTUP
(continued)