USER GUIDE
EdgeSafe 10G Modular Bypass | Firmware Rev Level: 0.3.3.2
6.62 Permitted IP support
The IBS supports SSH protocol. By default the SSH access is enabled.
The IBS supports restricted IP address access from HTTP (HTTPS), SSH, TELNET and SNMP.
By default access allowed from any IP address.
Restricted IP access rules:
Three parameters participate in acceptance of host IP address:
1. Network IP (NetIP)
2. Network MASK (NetMask)
3. Host IP (IP)
The access is accepted only if NetIP == IP & NetMask.
Maximum number of permitted IP ranges – 20.
6.62.1 Set/delete permitted IP range
New permitted IP range can be added by command “set_ mgmt_permit_ip”
Permitted IP range can be removed by command “del_ mgmt_permit_ip”.
Command Show parameters NetIp/NetMask or “all”.
With parameter “all” command remove all permitted IP ranges and the device will
receive commands from all IP.
6.62.2 Display permitted IP range
Permitted IP range can be displayed by command “show_ mgmt_permit_ip”
6.62.3 Check permitted IP range
Permitted IP range can be checked by command “check_mgmt_permit_ip”
Garland Technology | 716.242.8500 |
83
