GARDASOFT CC320, Руководство пользователя

Страница: 11 / 40

Mode Mode
Name Operation
0 OFF The output is set off. If the output is inverted (flag O is set) then the
output is logic 1, otherwise logic 0.
1 On The output is set high (on). If the output is inverted (flag O is set) then
the output is logic 0, otherwise logic 1.
2 Ptt Pulsed output triggered by a digital input. The delay and pulse width are
set as fixed times.
3 PtE Pulsed output triggered by a digital input. The delay is a fixed time. The
pulse width is a number of encoder pulses.
4 PEt Pulsed output triggered by a digital input. The delay is a number of
encoder pulses. The pulse width is a fixed time.
5 PEE Pulsed output triggered by a digital input. The delay and pulse width are
a number of encoder pulses.
6 Pd Pulse divider. Every <Pulse Delay> trigger pulses, the output is pulsed
for <Pulse Width> time.
7 Enc Pulsed output triggered by encoder pulses. The output is pulsed for
<Pulse Width> encoder pulses with the pulses separated by <Pulse
Delay> encoder pulses. The Input and Gate Input parameters are not
used.
8 bur Burst output. When triggered, <Gate Input> pulses are output. Each
pulse is <Pulse Width> long and the time between the end of one pulse
and the start of the next is given by <Pulse Delay>. The maximum
number of pulses that can be output is 250.
9 FrE Outputs a constant high frequency square wave. The frequency is
configurable. Further details available from Gardasoft.
10 buF Buffer an input by making the output the same signal as the input. If
there is gate input set, then the gate input signal enables the output – if
the gate input is off then the output is off. Flag O inverts the output and
Flag G inverts the gate input.
The output can be delayed by a fixed time given by the <Pulse Delay>
parameter. Note that any Gate Input is applied before the delay.
The E flag can be set to indicate when the output changes state.
11 buE Same as buF mode, except the output signal can be delayed by a given
number of encoder pulses.
12 brE Same as bur mode, except the pulse width and pulse spacing is a given
number of encoder pulses. (V017 firmware onwards)