Ganz digimaster DR-4FX1, Руководство по эксплуатации

Страница: 15 / 102

１５
System Setting
Motion Sensor
Set the motion sensor of the camera so that it can
detect a motion event.
1. From
<SYSTEM SETUP>
-
<CAMERA>
, select
<MOTION SENSOR>
.
2. Use the
[▲▼
◀▶
/ENTER]
buttons on the remote
control or use the mouse to specify the use of each
option item.
> ACTIVATION : turn on or off the motion sensor.
> MOTION MARK: Set it to
<On>
.
The video window will display the motion mark if a motion is detected.
> SENSITIVITY : Set the sensitivity level of the motion sensor to either Daytime or Nighttime.
> EDIT AREA : Specify the motion detection area.
3. To apply the change, click
<APPLY>
button.
4. When done, press the
[EXIT]
button on the remote control or click
<CLOSE>
button.
The confirmation message appears and you will return to the previous menu.

The motion detection sensitivity may differ depending on the characteristics of the
connected camera or installation environment.
Motion Area Setup
From the motion setup window, click
<EDIT AREA>
in the right corner.
1. Click
<EDIT AREA>
to move to the motion
area setup screen.
2. If using the remote control, press the
[ENTER]
button to mark the current position.
3. Use the arrow buttons to move to a desired block
and press
[ENTER]
. The area setup will begin.
Then, use the arrow buttons to specify the area.

Alternatively, you can use the drag-and-drop
method to specify or release the area using
mouse.
4. If you select the specified area again, it will be released.
5. Press the
[EXIT]
button on the remote control or
right-click any area to display the popup window
as in the right picture.