Galvanic Applied Sciences 943-TGS-CE, Руководство по эксплуатации

Страница: 131 / 158

Revision 5 131 August 2021
Figure 80: Spectrometer
1. Place the analyzer in Offline mode by toggling the Online / Offline control toggle
(Section 4.3.1) on the Analysis 2 panel to Offline (red).
2. Place the analyzer in back purge mode by pressing the F6 key on the keypad OR by
placing the X in the Back Purge check box on the Analysis 1 panel.
3. Access the purged control cabinet following proper user company and/or regulatory
agency procedure.
The control cabinet door may NOT be opened while the analyzer is
energized UNLESS the area is known to be non-hazardous. Observe all the
warning labels on the analyzer enclosures. To open the control cabinet door
while the analyzer is energized, the purge control box must first be
bypassed. Refer to Section 3.3.
DO NOT look at the end of disconnected fibres connected to the UV lamp or
place them in contact with skin. The intense UV radiation transmitted
through these fibres can cause eye and skin damage. Fibres should be
capped immediately after disconnection to prevent acidental exposure to
UV radiation.
4. Disconnect the USB cable from the front of the spectrometer (#1).
5. Disconnect the air trickle purge line connected to the bottom left corner of the
spectrometer (if present) (#3)
6. Disconnect the detector fibre connected to the top of the spectrometer by unscrewing
the nut and gently pulling it out of the SMA connector. (#2) Place an orange protective
cap over the end of the fibre to prevent damage.
7. Remove the retaining screws that hold the spectrometer to the mounting bracket. (#4).
Hold a hand under the spectrometer while removing it to prevent it from falling when
the last screw is removed.
1
2
3
4