Galvamet ROLL, Руководство пользователя

Страница: 8 / 20

Filter Timer
After the cooker hood has worked for 30 hours, once it is turned off, all the led switch on with a fixed light for 30 seconds in order to advise
that the aluminium filters need to be cleaned. When the motor is off, button “T1+T4”, if pressed for some seconds, will reset the timer. In
case this button is not pressed, the same operation will occur again after the cooker hood has been switched off. This operation will occur
every 30 hours, till achievement of 120 hours functioning. Once the cooker hood has worked for 120 hours and it is turned off, all the led
switch on with a blinking light for the following 30 seconds to remind the cleaning of the aluminium filters and the replacement of the active
charcoal filters, in case the cooker hood is in thr filtering version. Once the timer has been reset (always through a long pressure of the
button “T1+T4”) all the same process will occur after the next 30 hours exhausting.
MAINTENANCE
Always disconnect the hood from the mains before carrying out any maintenance or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that are designed to trap particles of fat contained in the fumes. The
metallic anti-grease filters must be washed at least once a month or, if present in this model, when indicated by the electronic notice, with
detergent in hot water (or in the dish-washer). The filters may discolour after a few washes. This is normal and does not mean they have
to be replaced. To remove the metal grease filters, use the handle (Fig. 3-A). It is recommended to refit the metal grease filters only if
perfectly dry.
ATTENTION: the grease collected in the filters can easily catch fire and it is therefore extremely important to clean the metallic filters on
a regular basis as per instructions.
The activated charcoal filters, if present, are designed to collect unpleasant odours in the cooking fumes. The air is then released purified
in the environment. The charcoal filters must not be washed, but replaced 2 or 3 times a year, depending on how much the hood is used.
New filters are to be requested directly to the manufacturer.
To replace the activated carbon filters, first remove the metal anti grease filters (Fig. 3-A). At this point the activated carbon filters can be
removed by rotating them about 90 ° from their position to release them from the interlocking tabs, then accompanying the filter
downwards, without the use of tools.
To reinstall the new activated carbon filters, reverse operations.
The hood features a LED light that, in addition to offering a good lighting and a significant energy savings, are guaranteed to last on
average 10 times more than traditional lights. For replacement, contact the Assistance Service.
In order to remove the remaining glue or any impurity, the cooker hood must be cleaned immediately after installation and after having
removed the protective film.
The cooker hood must be cleaned frequently both internally and externally (at least once a month).
Do not let dirt gather on the inner and outer surfaces of the hood.
To clean the exterior of the hood do not use either acid or basic products, or abrasive sponges.
Clean the hood with a sponge dampen in warm water and a little quantity of neutral detergent (for example dishwasher detergent), in
order to remove possible particles of grease.
Rinse with a damp cloth, removing all the detergent carefully, following the satin finish direction on the steel surface.
Drying is very important, especially in areas where water is particularly hard and leaves limestone.
All the ordinary and extraordinary maintenance can be performed without having to remove the hood.