13
20cm
20cm
Aviary
We suggest you use a two wire fence for protecting your aviary, as
shown in the diagram. The fence lines should run at 20cm (8") from
ground level and 40cm (16") from ground level. Run fence lines as
instructed for the Garden and Pond kit.
Using the supplied drill bit, drill a hole 2cm (3/4") deep into the
frame, approximately 2.5m (81/4 ft) apart and at corners.
Apply pressure when screwing the insulators in.
Wall top
Install Insulators
Wood: Drill a 2cm (3/4 ") hole with the supplied drill bit at 3m (10 ft)
intervals along the fence line and at corners. Screw in the insulator
completely while applying pressure.
Concrete: Drill a hole to the length of the wall plug at 3m (10 ft)
intervals and at corners. Insert the plug into it. This will help secure the
insulator once it is screwed in.
Tie the end of the first coil of wire to the base of the first insulator,
as illustrated. While keeping the wire taut, wind the wire around the
base of the next insulator and continue to wind around the base of each
insulator to the end of the fence line then tie to the last one.
With the second coil of wire, tie the wire to the top loop of the first
insulator, then pass the wire through all top loops of insulators and then
tie to the last one.
Note
The top and bottom wires must not be connected or touch each other.
The lower wire will connect to the earth stake.
1
2
1
2
3
Installing your Gallagher wall and aviary kit
