i Cod. 80000370 – 22.08.2012
PROGRAMMING OF THE CONTROLLER (DIXELL XR50CX)
Attention
: the access to the programming menus and the modification of the parameters are
exclusively reserved to installation and maintenance personnel. A wrong or improper modification of the
parameters can lead to malfunctions and/or to a lack of performances.
Parameters categories and access to the menus
Working parameters are grouped in two different categories:
1.
“Pr1” parameters
(user level – see parameter table)
2.
“Pr2” parameters
(Hidden Menu – see parameter table)
Access and setting type “Pr1” parameters (user level)
To change the parameter’s value operate as follows:
-
Enter the Programming mode by pressing the
SET
+
DOWN
buttons for 3sec. (the “°C” or “°F” LED
starts blinking).
-
Select the required parameter. Press the
SET
button to display its value.
-
Use
UP
or
DOWN
buttons to change the parameter value.
-
Press
SET
to store the new value and move to the following parameter.
-
To exit: Press
SET
+
UP
or wait 15sec. without pressing a key.
NOTE: the set value is stored even when the procedure is exited by waiting the time-out period.
Access and setting type “Pr2” parameters (Hidden Menu)
-
Enter the Programming mode by pressing the
SET
+
DOWN
buttons for 3sec. (the “°C” or “°F” LED
starts blinking on the display).
-
Release the buttons, then push them again and keep pressed for more than 7sec. The
Pr2
label will
be displayed immediately followed by the
HY
parameter (first parameter of the list). The complete
list of parameters is now accessible and modifiable.
-
Select the required parameter scrolling the list with the
UP
or
DOWN
buttons.
-
Press the
SET
button to display the value
-
Use
UP
or
DOWN
to change the parameter value.
-
Press
SET
to store the new value and move to the following parameter.
-
To exit: Press
SET
+ o or wait 15s without pressing any button.
NOTE: the set value is stored even when the procedure is exited by waiting the time-out period.
Attention :
in case of a power black-out before the save procedure, all parameter changes
previously applied are lost.
Содержание GIANO 70
