REM VECTOR SPEED IS 10000
VP -4000,0
REM BOTTOM LINE
CR 1500,270,-180
REM HALF CIRCLE MOTION
VP 0,3000
REM TOP LINE
CR 1500,90,-180
REM HALF CIRCLE MOTION
VE
REM END VECTOR SEQUENCE
BGS
REM BEGIN SEQUENCE MOTION
EN
REM END OF PROGRAM
These REM statements will be removed when this program is downloaded to the controller.
Executing Programs - Multitasking
The DMC-1600 can run up to 8 independent programs simultaneously. These programs are called
threads and are numbered 0 through 7, where 0 is the main thread. Multitasking is useful for
executing independent operations such as PLC functions that occur independently of motion.
The main thread differs from the others in the following ways:
1. Only the main thread, thread 0, may use the input command, IN.
2. When input interrupts are implemented for limit switches, position errors or command errors,
the subroutines are executed as thread 0.
To begin execution of the various programs, use the following instruction:
XQ #A, n
Where n indicates the thread number. To halt the execution of any thread, use the instruction
HX
n
where n is the thread number.
Note that both the XQ and HX commands can be performed by an executing program.
The example below produces a waveform on Output 1 independent of a move.
#TASK1 Task1
label
AT0
Initialize reference time
CB1
Clear Output 1
#LOOP1 Loop1
label
AT 10
Wait 10 msec from reference time
SB1
Set Output 1
AT -40
Wait 40 msec from reference time, then initialize reference
CB1
Clear Output 1
JP #LOOP1
Repeat Loop1
120
•
Chapter 7 Application Programming
DMC-1600
