VoIP Telephone.
16
5.4.2 Flush
mounting
To flush-mount the telephone to a wall:
6. Prepare a recess (at least 50mm, 2in deep) in the wall according to
the dimensions shown.
7. Mark the wall with hole centres based on the dimensions shown
(166 x 307mm, 6.5 x 12.1in). If necessary offer the faceplate up to
the wall to check alignment. Do not use the telephone as a
template for drilling.
8. Drill holes in the wall at the marked positions. Select appropriate
screws, wall plugs etc., for the type of wall, bearing in mind that the
weight of the complete phone is around 1.5kg (3.3lbs).
9. Route the cable to within the recess, and make connections to the
telephone as shown in section 6.5.
Secure the telephone to the wall taking care not to trap any wires. Note
that the gasket on the rear of the faceplate is intended to make a
weather seal when compressed against a smooth surface. Do not rely
on this gasket to keep water out if mounting directly to rough surfaces
such as brickwork – in these cases use additional sealant around the
edges to ensure a weatherproof seal.
Содержание Titan
Страница 29: ...29 VoIP Telephone 9 CE Declaration...
Страница 31: ...31 VoIP Telephone...
