GAI-Tronics Titan, Инструкция по установке и эксплуатации

Страница: 10 / 32

VoIP Telephone. 10
4. Ensure that all four plastic flanged bushes are in place and the rear
enclosure is screwed tightly to the surface to prevent any water
ingress through the punched holes.
5. Complete the installation by making the appropriate connections
(section 6.5) and re-fitting the face plate.
5.2.2 Pole mounting
Kit No 100-02-0208-001
This accessory is for mounting GAI-Tronics telephones on to the side of
round poles of 100mm to 200mm diameter (4 - 8in), or on to square or
rectangular section uprights of 100mm to 150mm (4 – 6in) across the
mounting surface.
NOTE:
Banding straps (large scale worm-drive clamps) are not included in this
kit and must be obtained separately. For details of where banding can
be obtained, refer to GAI-Tronics.
1. After punching through the flanged bushes in the rear enclosure (as
described in
WALL MOUNTING
), attach the pole mounting clamp
assemblies to the rear enclosure using the M6 x 25 screws
provided.
Note: only use the outer four holes, and ensure that the screws seat
properly in the plastic bushes to avoid water ingress.