Gaggia SYNCRONY COMPACT, Руководство по эксплуатации

Страница: 31 / 40

ENGLISH
• 31 •
• You can remove the coffee dispenser in
order to clean it (Fig.24):
- lower the dispensing unit nozzles
- take the dispensing unit as shown in Fig.
24, and remove it from its housing
- wash the whole unit with warm water.
10.1 The coffee disperser
The coffee dispenser (17) must be clea-
ned each time you fi ll the coffee bean
container or, anyhow, at least once a week.
• Switch off the appliance by pressing the
ON/OFF switch (7) to the “O” position and
remove the plug from the wall outlet.
• Open the service cover (15). Remove the
drip tray (12) and the coffee grounds
drawer.
• Remove the coffee dispenser, holding it by
its handle and pressing the “PUSH” button
(Fig.22)
• Wash the coffee dispenser only with hot
water: do not use detergents.
• Carefully wash the top fi lter (Fig. 23) and
make sure it is free from any coffee residues.
Then, thoroughly dry all its components.
• Carefully clean the compartment inside the
appliance.
• Holding it by its handle, insert the coffee
dispenser into its housing until it snaps into
place.
• Insert the coffee grounds drawer, the drip
tray plate and the drip tray.
• Close the cover (15).
11 DESCALING
Scaling occurs naturally when the appliance
is used. Approximately every 3-4 months you
should descale it; it is ready for descaling
when you notice a reduction in the water fl ow
or when the LED of the button (26) fl ashes.
If you wish to carry this out at home,
you can use a descaling product for
coffee makers that is non toxic and/or not
harmful and commonly available on the
market.
Caution! Never use vinegar.
To descale the appliance proceed as fol-
lows:
• Mix the descaler with water as specifi ed on
the package and fi ll the water tank.
• Switch ON the appliance with the ON/OFF
switch (7).
• Press the button (26) for at least 5 seconds
to select the descaling operating mode; the
LED emits a fi xed light.
• Direct the steam nozzle (14) toward the drip
tray.
• Position a vessel of adequate capacity under
the steam nozzle and turn the hot water
knob anticlockwise (16). The appliance star-
ts an automatic descaling cycle with pauses
preset by the manufacturer and managed
automatically by the appliance.
• At the end of the cycle, the fl ow of the de-
scaling solution is shut off and the 5 buttons
start fl ashing simultaneously.
• Turn the knob of the hot water nozzle (16)
clockwise to OFF. In this case, also the
warning light (27) fl ashes.
• Rinse the water tank and fi ll it with fresh
drinking water.
• Position a vessel of adequate capacity
under the steam nozzle and empty 2/3 of
the contents of the water tank by turning the
steam knob (16) anticlockwise; to shut off
the fl ow, turn the knob (16) clockwise.
• Let the appliance heat up and empty the
remaining contents of the water tank by
turning the steam knob (16) anticlockwise;
to stop the fl ow, turn it clockwise.
If you use a different product from the
recommended one, we recommend you
follow the instructions of the descaler manu-
facturer as specifi ed on the package.
If the descaling cycle is interrupted by
switching the machine OFF, this is re-
started when the machine is switched back
ON.