Tools required:
-
Flat screwdriver
-
Philips screwdriver, P1
-
Switch the machine off
and unplug.
-
Loosen the two screws (A) under the side grilles of the cup warmer by approximately
7 turns
and
release
the front panel from the hooks by pushing the screws
downward
.
-
Tilt the front panel forward to gain access to the wiring
connections
.
-
Disconnect
both wiring connections from BTA and the following connections from each BGX: CN1,
CN4, CN5, CN6
.
A
-
Place the front panel flat on a protected surface to avoid scratching it and to have access to the
screws on the back
.
BGX/BST control box
replacement:
