-
Loosen the screws holding the top of the panel (B) to remove it
.
-
Remove the
light diffuser
strip
.
-
Disconnect all
wiring harnesses
from the control box to be changed and remove its four screws
-
Also loosen the screws holding the adjacent
BGX control
boxes to leave enough clearance to be
able to
re
move
the control box
being
changed
.
DO NOT REMOVE/LOOSEN BTA SCREWS!
-
Position the new control box and
reassemble
.
B
Assignment of one or more BGX/BST control boxes
Reconnect
machine
to power and turn
o
n:
IMMEDIATELY
proceed to BGX assignment
.
Following BGX replacement, assignment
must be complete
(confirmed)
within 30sec after
powering machine on
.
The
replaced BGX
control box
[es]
flash green while awaiting the assignment of their positions
1°: G1 flashes
: press upper
left key
to change
assignment
2°:
When appropriate position
is selected - press upper right
key to confirm assignment
3°:
Assigned position stops
flashing when confirmed -
machine will start normally
after software booting
