Gaggia Milano La Reale, Инструкция по установке и эксплуатации

Страница: 12 / 88

- While using the machine, the operator is
responsible for any third parties in the work
zone.
- The personnel assigned to the machine
(installer, operator, maintenance technician,
etc.) is required to notify the manufacture
of any defects or deterioration encountered
that could compromise the system's original
safety conditions.
- Prior to installing and commissioning the
machine, the installer is required to verify the
environmental conditions in order to ensure
the safety and hygiene of the operators, the
users, and any exposed persons.
- The machine must only be installed in
locations where its use and maintenance are
reserved exclusively for qualified personnel.
- The machine's installation must only be
performed by a qualified and authorised
installer.
- The machine must only be used in adequately
lit environments.
- For safety reasons, any worn or damaged
parts must always be promptly replaced with
original spare parts.
- The power cable must be regularly checked
to ensure that it is in perfect condition. Any
damage encountered on the cable must
never be repaired using electrical tape or
clamps under any circumstances; if the power
cable is damaged, it must be replaced by the
manufacturer or its technical support service.
- The internal parts must only be cleaned with
the machine off and disconnected from the
power outlet.
- Only use appropriate products to clean the
machine and its various parts, and avoid any
risks of food contamination.
- Only qualified and authorised maintenance
personnel may remove the protective devices
to perform interventions on the machine's
internal parts.
- Do not expose the machine to the elements
(sun, rain, etc.).
- Prolonged stoppages (downtime) at
temperatures below 0°C (zero degrees
centigrade) can result in serious damage to
the pipes and boilers; prior to every prolonged
stoppage, empty the water circuit completely
and drain all the pressurised parts.
- The machine must be installed in the
horizontal position. The support surface
mustn't have a slope greater than 1°. In order
to ensure normal operation, the machine
must be installed in a location where the
ambient temperature falls within the range of
+5°C and +32°C, with a relative humidity no
greater than 70%. Do not use jets of water
or install in a location where jets of water are
utilised.
- It is forbidden to remove the machine's safety
devices.
- It is forbidden to operate the machine with
parts of its casing removed.
- The components of the packaging must be
disposed of at an appropriate disposal centre,
and must never be left unattended or within
reach of children, animals, or unauthorised
persons under any circumstances.
- The manufacturer shall bear no responsibility
for any injuries or property damage caused
by machine interventions carried out by
unqualified or unauthorised individuals.
ENG
6 GENERAL INFORMATION