Gaggenau CV 282, Инструкция по эксплуатации

Страница: 16 / 64

16
en
Operating the appliance
1
Operating the appliance
Operating the appliance
This chapter explains how to set a hotplate. The table
shows heat settings and cooking times for various
meals.
m
Warning – Risk of burns!
The ventilation grille will quickly become extremely hot if
it is placed on the hob. Never place the ventilation grille
on the hob. Do not place any pans or other hot objects
on the ventilation grille.
Note: Switch on the ventilation system when you start
cooking and switch it off again a few minutes after you
have finished cooking. This is the most effective way of
removing steam from the kitchen.
Note: Never use the appliance without the container,
metal grease filter or ventilation grille.
Switching the hob on and off
Use the main switch to switch the hob on and off.
When you first switch on the appliance, you are
prompted to set up your home network. The
D
symbol
will be lit dimly for a few seconds on the display panel.
To begin setting up the connection, touch the
·
symbol
and proceed in accordance with the information given in
the section entitled
~
"Home Connect"
. To exit the
initial set-up, touch any symbol.
To switch on: Position the twist knob on the control
panel. Touch the
#
symbol. The symbols for the
cooking zones and the functions available at this time
light up.
‹
lights up next to the cooking zones. The hob
is ready for use.
To switch off: Touch the
#
symbol until the display
goes out. All the hotplates are switched off. The
residual heat indicator remains lit until the cooking
zones have cooled down sufficiently.
Notes
– If the appliance has not been connected to your
home network or the connection has been broken,
network connection initial set-up will be activated
whenever you switch on the hob.
– The hob switches off automatically if all cooking
zones and the ventilation have been switched off for
more than 20
seconds.
– The selected settings are stored for 5 seconds after
the hob has been switched off.
If the hob is switched back on during this time, the
heat settings that were previously set will flash. To
apply these settings, tap on the twist knob within
the next 5 seconds.
If you do not tap the twist knob or if you touch a
different sensor button, all the previous settings will
be deleted.
Setting a hotplate
Set the required hotplate using the twist knob.
Heat setting 1 = lowest setting.
Heat setting 9 = highest setting.
Every heat setting has an intermediate setting. This is
shown in the hotplate display as
.5 .
Notes
– To protect the fragile parts of your appliance from
overheating and electrical overloading, the hob may
temporarily reduce the power.
– In order to prevent the appliance from producing
excess noise, the hob may temporarily reduce the
power.
Selecting a hotplate and heat setting
The hob must be switched on.
1 Select the hotplate. To do this, touch the twist knob
in the appropriate area for the required hotplate.
2 Within the next 10 seconds, turn the twist knob until
the required heat setting appears in the heat setting
display.
The heat setting is set.
Notes
– When placing an item of cookware on the flexible
cooking zone, it must be positioned correctly
according to size; see the section entitled
~
"Flex
function" on page 21
.
The cookware is detected and the cooking zone is
selected automatically. You can now configure the
settings.
– If the indicators flash after you have changed the
settings, check whether the cookware is suitable for
induction cooking. See the section entitled
~
"Cookware test" on page 50
.
Changing the heat setting
Select the hotplate and change the heat setting using
the twist knob.
Z Z