Gage CompuScope 14100C, Руководство по аппаратному обеспечению и инструкция по установке драйверов

Страница: 141 / 174

CompuScope 1610C 135
DYNAMIC PARAMETERS
Measured using 1 MHz sine wave input at 10 MS/s with amplitude of 95% of full scale on the ±1V range.
Typical values listed below.
SNR: 70 dB
SFDR: 71 dB
SINAD: 66 dB
THD: -68 dB
ENOB: 11.5 bits
ACQUISITION MEMORY
Data Storage: In on-board memory
Memory Sizes: 1M, 8M, 128M, 1G (16 bit samples)
Maximum memory
for each channel:
Up to half on-board memory per channel
TRIGGERING
Number of Trigger Inputs: 2 per card
Source:
CH 1, CH 2, EXT or Software
Type: Analog triggering
Sensitivity: ± 20% of full scale
Level Accuracy: ± 10% of full scale
Slope: Positive or Negative, software selectable
Post Trigger Data: 128 points minimum.
Can be defined with a 64 point resolution
EXTERNAL TRIGGER
Impedance: 1 M
Ω
, 30 pF
Input Type: Single-ended analog
Amplitude: Absolute Max ±15 V
Voltage Range: ±1 V and ±5 V
Bandwidth: 10 MHz
Connector: BNC
TRIGGER OUTPUT
Signal Type: TTL
Active Edge: Rising (low-to-high)
Synchronization: Synchronized to sampling clock
INTERNAL CLOCK
Source: Clock oscillator
Accuracy: ± 50 ppm (0 to 70 degrees Celsius)
EXTERNAL CLOCK
Maximum Frequency: 20 MHz, maximum
Uses 2x decimation filter
Clock must be present during initialization
Minimum Frequency: 2 kHz
Signal Level: TTL
Required Duty Cycle: 50% +5%, -0% at 20 MHz