Gage CompuScope 14100C, Руководство по аппаратному обеспечению и инструкция по установке драйверов

Страница: 82 / 174

76 CompuScope 85GC
INTERNAL CLOCK
Source: Crystal oscillator
Accuracy: ± 50 ppm
DYNAMIC PARAMETERS
Measured using 100 MHz sine wave input at 5 GS/s, dual channel mode with amplitude of 95% of full scale on
the ±1V range. Typical values listed below:
SNR: 38 dB
SFDR: 47 dB
SINAD: 37 dB
THD: -42 dB
ENOB: 6.01 bits
ACQUISITION MEMORY
Data Storage: In on-board memory
Maximum On-board
Memory Size:
10,000 samples on each of the two channels
TRIGGERING
Number of Trigger Inputs: 1 per system
Source:
CH 1, CH 2, EXT or Software
Type: Slope-and-level and software
TV Trigger Mode Type: NTSC and PAL
Trigger Level: Controlled by on-board DAC
Sensitivity: ± 5% of full scale (DC to 50 MHz)
± 12.5% of full scale (50 MHz to 500 MHz)
This number specifies the minimum required signal amplitude to cause a trigger to
occur. Smaller signals are rejected as noise.
Level Accuracy: ± 5% of full scale
Slope: Positive or Negative
Pre-Trigger: From zero to almost 100% of record length. All captured data that is not part of
post-trigger depth is pre-trigger data.
Post-Trigger Depth: 500 points minimum.
Can be defined with 100 point resolution
EXTERNAL TRIGGER
Impedance: 1 M
Ω,
20 pF
Amplitude: Absolute Max ±15 Volts
Voltage Range: ±800 mV and ±8 V
Coupling: AC or DC
Bandwidth: 300 MHz
Connector: BNC
MULTI-CARD SYSTEMS
Operating Mode: Multiple/Independent
Max. number of cards: 8