G-Tek LmNet - PRO 614-00, Руководство по эксплуатации

Страница: 47 / 53

G-Tek Corporation Private Limited 46
T
ROUBLESHOOTING
G
UIDE
9.1 O
PERATION
T
ROUBLESHOOTING
9.1.1 How to turn on the LmNet?
•
First, connect the 15 Volt 1.2 Amp DC Adaptor with the LmNet. Connect the adaptor to 230V
plug and ON the switch for that plug. After pressing that switch on, red led will be turn on
which is indicated by “PWR” on the front panel of LmNet and the LmNet will get turn on.
Figure 53 Power on indication on LmNet
9.1.2 What to do if user wants to communicate recorder using TCP/IP?
•
For using LmNet communication in TCP/IP mode, connect the one end of Ethernet cable to
the Ethernet port given at the bottom side of the LmNet and the other side of the cable to the
PC’s or MODBUS’s Ethernet port. Then, Configure TCP/IP communication. Refer section 3.4
for figure of Ethernet port and Ethernet cable.
9.1.3 How to connect the sensor to be used with the LmNet?
•
To connect any of the mentioned sensor as an input, there is a slot available at bottom side of
LmNet. Every sensor has its positive and negative wires. Connect those wires respectively to
the slots correspondingly in the LmNet (refer
Sensor wiring section).