G-Tek LmNet - PRO 614-00, Руководство по эксплуатации

Страница: 25 / 53

G-Tek Corporation Private Limited 24
7.2 C
ONFIGURABLE
I
TEM
Table 2 Configurable Items
Sensor Types
1) RTD (Pt-100)
2) TC - J
3) TC - K
4) TC - C
5) TC - R
6) TC - S
7) TC- T
8) TC- B
9) TC- E
10) TC- N
11) 4-20mAmp
12) 0-20mAmp
13) -1000.0 to + 1000.0mV & 0.0 to +1000.0mV
14) -5000.0 to + 5000.0mV & 0.0 to +5000.0mV
Batch Start/Stop Only after starting the batch the data storage will start.
Memory setting
1) Roll Over: - Memory roll over for store the data also after memory full
and this storage will be start from the beginning of memory location.
2) Stop on full: - Memory stop on full for stop the data storage after
memory full.
Clear memory Delete the stored data and clear memory for next batch.
Channels to scan
The parameter value for all channel, digital inputs and digital outputs will
be display with rolling action. Also scan channel with Freeze action.
Set Date and Time Set internal real time clock of LmNet
Store Interval Interval of data storage in internal memory.
Range Low
The minimum value shown on display when process inputs like 0-1 Volt,
0-20 mAmp & 4 - 2O mAmp are at 0V, 0 mAmp & 4 mAmp, respectively.
Span
The difference between maximum & minimum value used for process
inputs.
Offset
A small correction may be required when actual sensor is connected to
the LmNet. This is a mathematical value which is directly added to the
reading.
Multiplier
A value to remove any scale error. This is a mathematical value which is
directly multiplied to the reading.
Displayed reading = (reading x multiplier) + offset
Resolution Measure the accuracy of the output value
Alarm set point High The upper limit of value, after which alarm is generated
Alarm set point Low The lower limit of value, after which alarm is generated
Communication Parameters:
Device Address Address of LmNet for communication with computer
Saving Configuration Saving Batch & channel parameters